SooperLooper v1.6.14 click in sync'ed loops...

[baking666]

I've found that when I sync loops the first loop works fine....but loops sync'ed with it have a 'click' or 'pop' at the loop point

Also when I make connections to sooperlooper loops via qjackctl connections, I'll get a nasty 'crack', 'pop', 'click' or the like, everytime I make a connection....no xruns just noise at connection??

[baking666]

...adding to my first post.

the problem is when i press record to stop recording loop it 'clicks' so therefore adds that to loop

[baking666]

Ok I've further discovered...that I'll get added noise in my loops when i press the record button to stop recording a loop so that then becomes the beginning of the loop. So if i were to record a loop with just one continuous note for 5 seconds, the created loop would have a click from the action of stopping the loop recording So every five seconds I'd get a click in the loop...instead of the sound of one note repeating every five seconds...not good

[jesse]

Check the value of your xfade parameter. Normally loops ends are always crossfaded with the beginning on loop completion to avoid exactly that. If that isn't it, attach a saved SL session (no audio) here... thanks.

[baking666]

xfade parameter? Were do i find this

After more playing around...it's just a problem with continuous sounds...if I record a loop with a sequence of notes as would be the common use...it works good.

I've attached .slsess file

[M 先生]

allo,

i'm experiencing the same

http://soundcloud.com/ft10d/change here i've put two distinct timeline click for your convenience, i'm only hearing it with headphone, but it's annoying. [REMOVE]

http://sites.google.com/site/muzx01/Capture-1.png this is a pic of my setup, should i increase/decrease the "xfade" (currently 64) to avoid this ?

a little help understanding would be appreciated,

thx, M 先生,

[M 先生]

my bad, to much echo!

anyway, i've edit everything

thx again,